Natures Garden's Pillar of Bliss WaxTM- A blend of soywax (more than 50%) and paraffin wax used for poured votive and pillar candles. It is also the wax we suggest using when making candle wax tarts. Pillar of Bliss Wax has excellent fragrance retention with good cold and hot throw characteristics. Pillar of Bliss Wax comes in granulated form.
Instructions for using Pillar of Bliss Wax: Melt wax to 195 degrees, and add coloring. Drop melted wax temperature to 180 degrees and add 1 ounce of fragrance per pound of melted wax. Pour 3/4 of your melted wax at 175 degrees into your molds. Keep the remaining wax for your second pour. Allow the candles to set up at room temperature. The wax will naturally sink in the middle. Heat the remaining 1/4 of your wax to 165 degrees, and top off your candles in order to fill in the sink holes. Allow candles to cool at room temperature. Pop set-up candles out of the molds.
Nature's Garden Print Page
42109 State Route 18 Wellington, OH 44090
PH(440-647-0100) FX (440-647-0220)
Material Safety Data Sheet 11/12/2012
Product Name: Pillar of Bliss Wax
Physical / Chemical Characteristics:
Ingredients: Soy/Petroleum Wax Blend for Votives and Pillar candles.
|Boiling Range: N/A||Specific Gravity: ~..80-.90|
|Vapor Density: N/A||Evaporation Rate: (_________=1)|
|Meting Point: 132-136F||Material V.O.C.: N/A|
|Solubility in Water: Insoluble||Percent Volatile by Volume (%): 100%|
|Vapor Pressure (mm Hg @ Temp): N/A||Appearance: A yellow to white solid|
|Flash Point: ~ >500F Stability: Stable||HMIS CODES: H/1 F/1 R/0 P/0|
Fire and Explosion Data: Extinguishing media: Use foam, dry chemical, & CO2. Special firefighting procedures- Self contained breathing apparatus & protective clothing should be worn when fighting fires involving chemicals. Fire and explosion hazards: None known.
Reactivity Data: Conditions to avoid: None. Materials to avoid: Strong oxidizing agents. Decomposition of byproducts: CO2, CO, Fumes. Hazardous polymerization: Will not occur.
Health Data: Inhalation and symptoms of exposure: N/A. Skin and eye contact and symptoms of exposure: N/A. Skin absorption and symptoms of exposure: N/A. Ingestion risks and symptoms of exposure: N/A. Carcinogenicity: N/A/.
Emergency & First Aid Procedures: Inhalation: seek fresh air immediately, if breathing is difficult- see doctor. Eyes: Flush immediately with clean water for at least 15 minutes. Contact doctor. Skin: if burned, see doctor. Ingestion: N/A.
Hazardous Ingredients/ SARA III Information: This proprietary material contains the following toxic chemicals subject to the reporting requirements of section 313 of Title III of the superfund amendments and reauthorization act of 1986 and 40 CFR Part 372. : None
The information in this MSDS was obtained from current and reliable sources. However, the data is provided without any warranty, expressed or implied, regarding its correctness or accuracy. Since the conditions for use, handling, and storage and disposal of this product are beyond control, it is the responsibility of the user both to determine safe conditions for use of this product and to assume liability for loss, damage, or expense arising out of this product's improper use. No warranty expressed or implied regarding the product described herein shall be created by or inferred from any statement or omission in this MSDS.