3D Popsicle Soap Mold: A 3D mold with a pour spout.
To use, you will need to trim around each mold half and then secure the two mold halves with tape (we suggest blue painter's tape or duct tape.) Place the mold in an upright position and then pour the melted soap into the pour spout and insert your wooden popsicle stick using our soap clips. Allow the soap to set up firmly and then dissamble the two mold halves. You'll have a perfectly formed 3D soap. Pouring temperatures should not exceed 145 degrees F. Pouring above these temperatures may warp or damage the mold.
Mold Market designs and manufactures high quality plastic soap molds for all occasions. Our multi cavity custom molds designs are suitable for hot and cold process soap making, melt & pour soap making, candle making, and ceramic crafts.
Natures Garden is a distributor of Mold Market Molds. In the good ole USA. Mold Market is committed to providing jobs for American workers and to supporting domestic manufacturers and suppliers. Our molds are American made and we are proud of this fact.
Mold Market molds are produced in United State factories. Many mold companies in the industry have moved production overseas to take advantage of low labor costs and generally cheaper production costs. We are saddened to find that some companies are advertising Made in the USA when this is not true. Mold Market elects to provide jobs to the U.S. workforce despite the competition from lower cost imports. We hope that you will support us in our effort to provide high quality designer molds for discriminating consumers desiring U.S products.
Mold size and pouring temperature of soap will determine set up time. It is imperative that you allow soap to cool completely before trying to remove from any mold. Depressions will occur in the top of mold if you try to release soap by force. Allow molded soaps to sit for at least 1 hour for best results. Gently pull the at the sides of the mold. This releases entrapped air between the mold and soap. Using firm, but gentle pressure, push on the top of mold until soap is released. If you are still having difficulty, place mold in the freezer for 10-15 minutes.
Mold Tips for CP (cold process) soapers: